Avaya BCM 2.0 Programming Guide de l'utilisateur télécharger pdf (Page 370)

100

101

370 Appendix A: Network Examples

Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01

PRI dialing plan example for 2-way DID

The following list shows the general steps involvedin configuring a dialing plan for

two-way DID using a Public service. In this example the user dials the prefix 8 to

place a call over a PRI line.

1. Choose Resources, Telephony, Hardware and configure the DTI (EE-DTM)

for PRI.

2. Select Public as the protocol.

3. For incoming calls, program target lines to match the DID digit that is being

received on the PRI interface.

4. Set Dial Out to None.

5. Select PRI-A as the line pool.

6. Set ServiceType to Public.

7. Choose Services, Routing Service to enter a Destination Code (8 in this

example).

8. Set Absorb Length to All.

9. Provide access to the PRI Pool for the set that you are dialing out from. This is

programmed in Terminals & Sets.

10. Define received digits for target lines.

11. Define limits for incoming and outgoing public calls, see Programming Call

by Call service selection on page 168.

Note: 2-way DID does not have to be configured for Call-by-call service.

PRI DID and 2-way DID

When configuring PRI DID with 2-way service, the channels programmed as DID

at the CO must be the lowest B-channels on PRI. On your Enterprise Edge system,

the BchanSeq mode must be set to descending. In this configuration, all calls on

PRI must be Public service.

For example, channels 1 to 4 are configured as DID at the CO. The CO uses

ascending mode for B-channel selection, and Enterprise Edge uses descending

mode.

1 2 ... 365 366 367 368 369 370 371 372 373 374 375 ... 445 446

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 2.0 Programming Guide de l'utilisateur Page 370

Commentaires sur ces manuels

Produits connexes et manuels pour Passerelles/contrôleurs Avaya BCM 2.0 Programming