Avaya BCM 2.0 Programming Guide de l'utilisateur télécharger pdf (Page 184)

184 Configuring Enterprise Edge Services

Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01

Alarm time (AL) feature

The Alarm time feature provides an alarm clock capability on Enterprise Edge and

analog telephones that connect to an ATA or an ASM. You can program both room

sets and common sets to sound an audible alert at time you request.

You can program one Alarm time within a 24 hour period on a room or common set

and you must reset the alarm daily. When the alarm sounds, all sets in a given room

alert. When you cancel the alarm on any set cancels the alarm on all the sets in the

room. A new Alarm time entered on a room or common set overwrites any alarm

set previously.

If the Enterprise Edge system experiences a power failure, the failure can result in

lost Alarm times. When the Enterprise Edge system is running and the system’s

time resets, the missed Alarm times alert. At all times, the Enterprise Edge system

allows up to a maximum of 25 sets that can alert at the same time.

For more information about programming this feature, see the Enterprise Edge

Feature Telephone Programming Guide.

Service change time

The Hospitality setting allows you to enter the time when occupied rooms change

state from Service done to Service required. The Service change time is an primary

part of the Room condition (RC) feature.

To change the service time:

1. Choose Services, Telephony Services,andclickontheHospitality heading.

2. Type the time in the Service change time box according to the following

format and press Enter:

hh is a number from 00 to 23

mm is a number from 00 to 59

Desk password

The Desk password setting controls access to all Hospitality Services

administrative features. The default Desk password is 4677. It is recommended that

you change the password to prevent unauthorized use.

To change the Desk password:

1. Choose Services, Telephony Services,andclickontheHospitality heading.

2. Type a password (1 to 6 digits) in the Desk password box and press Enter.

Room condition password

The Room condition password setting controls access to the Room condition

feature (ƒ°‡ﬂ). The default Room condition password is None.For

more information about using ƒ°‡ﬂ,seetheEnterprise Edge Feature

Telephone Programming Guide.

1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 445 446

Pas de commentaire

Avaya BCM 2.0 Programming Guide de l'utilisateur Page 184