Avaya BCM 2.0 Programming Guide de l'utilisateur télécharger pdf (Page 196)

196 Configuring Enterprise Edge Services

Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01

To modify address ranges:

1. Click an address in the address range table.

2. On the Configuration menu, click Modify Address Ranges.

The Address Range dialog box appears.

3. Type the necessary changes in the fields.

4. Click the Save button to save the modifications.

To add an address range:

1. On the Configuration menu, click Add Address Range.

The Address Range dialog box appears.

2. In the Range box, type the range identifier.

The range box uniquely identifies a range value in the scope. The value for

this setting must follow certain conventions. It must always start with the

prefix 'R' followed by a unique number identifying the range in the table. For

example, 'R2' is a valid name. Specify nonrecurring values for the unique

number. If you specify an existing range name, it modifies the existing range.

If you use nonsequential numbers the system automatically reassigns

sequential numbers. When you modify a range, you cannot change the range

name. The range name does not have any significance other than identifying

an entry.

3. In the Start Address box, type the start address.

4. In the End Address box, type the end address.

Scroll down to see all setting fields.

Make sure the start address and end address are in the same subnet.

5. Click the Save button to save the address range.

To delete an address range:

1. Click an address in the Address Range table.

2. On the Configuration menu, click Delete Address Ranges.

A dialog box appears asking you to confirm the deletion.

3. Click the Yes button to confirm the deletion.

Note: When you delete or modify an IP Address range it removes any

excluded addresses that are in the original address range value.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 445 446

Pas de commentaire

Avaya BCM 2.0 Programming Guide de l'utilisateur Page 196