Avaya BCM 2.0 Programming Guide de l'utilisateur télécharger pdf (Page 171)

Configuring Enterprise Edge Services 171

P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide

The operation of some features varies if the Enterprise Edge set is part of a Hunt

group. The table below shows the affected Features.

Adding or removing members from a group

Any Enterprise Edge set, or portable can be a members of a Hunt group. An

Enterprise Edge set can be in more than one Hunt group but is considered a member

in each Hunt group, increasing the total number of members in the system.

There can be only one appearance of the same Hunt group on a set. Hunt group DNs

cannot be members of other Hunt groups. A DN can be associated with a member

of a Hunt group and is called a member DN.

Consultyourcustomer service representative to determine your Huntgroup number

range.

To add a member to a Hunt group:

1. Choose Services, Telephony Services, Hunt groups.

2. Click a Hunt group (Hunt group 1-30).

Feature Description

Call Forward All Calls The system ignores Call Forward All Calls feature and the

Hunt group call rings at the set.

Call Forward No Answer The system ignores Call Forward No Answer and the

Hunt group call continues to ring until the hunt time

expires.

Call Forward on Busy The system ignores Call Forward on Busy and the Hunt

group call continues to ring until the hunt time expires.

Do not Disturb on Busy If this feature is active, the set will not receive notification

of incoming Hunt group calls.

Group Pickup If a set is part of a Hunt group and a call pickup group,

then an incoming Hunt group call can be picked up from

any set that is in the call pickup group.

Transfer via Hold The system support transfer for Hunt group sets; however,

you cannot Transfer via Hold. Once you answer a call on

a Hunt group set, its appearance disappears from all other

sets in the Hunt group so that other calls can come in on

the same line.

Priority Call You cannot make Priority calls to Hunt group DNs.

Ring Again You cannot use Ring Again when calling a Hunt group

DN.

Line Redirection The Allow redirect attribute should be set to N for lines

assigned to Hunt groups. For more information, see

Capabilities on page 98.

Page Zones You cannot include Hunt group DNs in a Page zone.

Voice Call Hunt groups cannot accept voice calls. Answer buttons

have no appearances for voice calls, and the set does not

ring.

1 2 ... 166 167 168 169 170 171 172 173 174 175 176 ... 445 446

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 2.0 Programming Guide de l'utilisateur Page 171

Commentaires sur ces manuels

Produits connexes et manuels pour Passerelles/contrôleurs Avaya BCM 2.0 Programming