Avaya BCM 2.0 Programming Guide de l'utilisateur Page 111

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 446
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 110
Configuring Enterprise Edge Services 111
P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide
Trunk/line data
The Trunk/line data attributes allow you to program settings for lines that affect
how Enterprise Edge communicates with other switches, and allows you to
determine how lines (including target lines) are used in Enterprise Edge.
To configure a trunk or line:
1. Choose Services, Telephony Services, Lines, Line nnn.
2. ClickontheTrunk/line data heading.
3. If you have a T1 module, select a trunk type: Loop, E&M, DID, Ground,
or Fixed data channel.
Any other module shows the trunk type but you cannot change this setting.
For more information about trunk types, see Trunk type on page 115.
Note: You can only change the trunk type setting for lines connected to an
T1 module. All other lines are automatically configured based on the
type of hardware module present. VoIP is automatically assigned as
the trunk type to Lines 001 to 014 and cannot be changed.
Trunk/line data settings vary depending on the type of trunk that has been
programmed and the hardware to which the trunk is connected. The following
table lists the options that are available for each trunk type. A checkmark
indicates that the option is present.
Trunk type
Loop
start
Analog
Loop
start
Digital
Ground
start
Digital
DID
Digital
E&M
Digital
BRI-ST PRI
lines
Target
lines
VoIP DASS2 DPNSS
Line type √√ √ √
Dial mode √√ ——
Received # —— —√
If busy —— —√
Prime set √√
CLID set √√
Auto
privacy
√√
Trunk
mode
√√ —— ——
Answer
mode
√√ —√
Answer
with DISA
√√ ——
Link at CO √— ——
Vue de la page 110
1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 445 446

Commentaires sur ces manuels

Pas de commentaire