Avaya BCM 2.0 Programming Guide de l'utilisateur télécharger pdf (Page 248)

248 Configuring Digital Private Network Signalling System1

Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01

User Actions

The party receiving a Call Offer has three choices, as follows:

• Ignore it. After a programmed time interval, the Offer request will be removed.

• Reject it. If the user activates Do Not Disturb on Busy (DND) when the Call

Offer request is made, the request is removed from the set. The calling party is

informed of the rejection.

Acall cannot be offered to a set with DND active. The line indicator for external

incoming calls still flashes.

• Accept it. The Offer is accepted by releasing the active call.

Note: Forward on Busy takes priority over DND on Busy. Call Offer cannot be

accepted by putting an active call on hold.

Route Optimization

Route Optimization is a DPNSS 1 feature for Enterprise Edge that lets calls follow

the optimum route between two end PBXs. This allows efficient use of network

resources.

Route Optimization is initiated by the system and is transparent to the user.

However, in some cases the user may see a call switch from an appearance on the

set to another appearance key or from an intercom key to the appearance key or vice

versa. This occurs when Enterprise Edge receives a Route Optimization request and

initiates a new call to follow the optimal route.

If a set is active on a private line call, the Route Optimization call being established

may go on a public line. This will cause a loss of privacy on that line.

Data calls are rejected by Route Optimization in order to ensure the data

transmission is not affected.

Certain situations result in Route Optimization not taking place. For example, calls

that are usingHold, Parking or Camp featureswill not undergo Route Optimization,

and if a Route Optimization call undergoes Diversion, the Route Optimization is

dropped.

Setting Route Optimization

There is no system programming required for the feature when Enterprise Edge is

working as a terminating PBX; however, Enterprise Edge must have a private

access code programmed that maps to a valid destination code or line pool code on

DPNSS lines. Further, Allow redirect must be set to Y. For more information, see

Capabilities on page 98.

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 445 446

Pas de commentaire

Avaya BCM 2.0 Programming Guide de l'utilisateur Page 248