Avaya BCM 2.0 Programming Guide de l'utilisateur télécharger pdf (Page 215)

Configuring Enterprise Edge Services 215

P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide

The following table shows parameters required for IPX static routes:

Adding Static Service for IPX

1. ClickontheIPX Routing key to expand the heading.

2. Click on the interface that you want to configure. For example, LAN1.

3. Under the Configure menu choose Add Static Service.

The Static Routes dialog box appears.

4. Configure the LAN1 (and WAN1, WAN2, etc.) static service table attributes

according to the table below:

The attributes for adding Static services in the IPX network are:

5. Click the Save button to save your settings.

Attribute Description

Static Route

(SR#)

Enter a Static Route number.

Net Number IPX Network Number identifies the destination network for the routing table

entry. The permitted value is 4-byte in hexadecimal format. The default value

is None

Next Hop MAC

Address

Shows the MAC address of the next hop router to reach the network defined

in the NetNumber box. The permitted value is 6-byte in hexadecimal format.

The default value is None.

Ticks Time required (in 1/60 seconds) to reach the destination network. The values

are 1 to 32,767. The default value is None.

Hops Shows the number of hops that must be crossed in order to reach the

destination network. The permitted values are 1 to 15. The default value is

None.

Attribute Description

Static Service Show the service type (SS Number). The permitted value is in 2-byte

hexadecimal format. The default value is None.

Type Allows you to specify the SAP service type. Use a 2 byte hexadecimal

number. You can use the value 0xFFFF to match services of any type.

Name Shows the static service name. The permitted values can use up to 48 bytes. A

wildcard character (*) can also be selected to indicate all service names.

Network Shows the network part of the service address. The permitted value uses 4

bytes in hexadecimal format. The default value is None.

Node Shows the node part of the service address. The permitted value uses 6 bytes

in hexadecimal format. The default value is None.

Socket Shows the socket part of the service address. The permitted value uses 2 bytes

in hexadecimal format. The default value is None.

Hops Shows the number of hops to reach the destination network. The permitted

values are 1 to 15. The default is None.

1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 445 446

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 2.0 Programming Guide de l'utilisateur Page 215

Commentaires sur ces manuels

Produits connexes et manuels pour Passerelles/contrôleurs Avaya BCM 2.0 Programming