Avaya BCM 2.0 Programming Guide de l'utilisateur télécharger pdf (Page 135)

Configuring Enterprise Edge Services 135

P0911588 Issue 01 Enterprise Edge 2.0 Programming Operations Guide

A valid destination code must be used. See Destination codes on page 131. View

existing destination codes before entering a new code.

The destination code can use a different route depending on the Schedule. In this

example, the system uses Route 002 (which uses Line pool B) to take advantage of

the lower cost when the system is in normal mode.

• The route for the first schedule appears: Normal:. Type the defined route

number 002.

Adding a long distance carrier access code

In many cases, long distance service uses the same lines as local service but is

switched to a specific carrier using an access number (sometimes called an equal

access code). Programming for routing can include the access number so users do

not have to dial it every time they make a long distance call.

1. Create a route that uses a line pool containing local lines only.

2. Program the route to use a line pool containing the lines used to access the

long distance carriers.

3. Type the dial out digits, which are the same as the access digits. For example,

if the access code is 10222, the dial out digit is 10222.

4. Create a destination code 91: 9 (for outside access) and 1 (for long distance).

A valid destination code must be used. See Destination codes on page 131.

5. Set Absorbed Length to 1. The 9 is only used internally and should be

dropped; the 1 is needed to direct the call to the public carrier network.

Tips

The digit absorption setting (Absorbed Length) only applies to a maximum of

two schedules.

Setting Absorbed Length to 0 minimizes the effort involved in preparing

destination codes. With a 0 setting, the actual digits dialed by a caller are

preserved in the dialout sequence. Programming a dial out sequence as part of

the route is not necessary.

If rates change depending on the time of the day or week, a different route can

be used for the same destination code 1 when a particular schedule is in use.

See

Programming for least cost routing on page 136.

Tips

The destination codes 9 and 91 used in the examples cannot be used together.

If the destination code 91 is needed to direct long distance calls, you must

create a separate set of codes that use local calling routes. These codes would

be, for example, 90, 92, 93, 94, 95, 96, 97, 98 and 99. See

Wild card

character on page 131 for information on programming destination codes.

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 445 446

Pas de commentaire

Avaya BCM 2.0 Programming Guide de l'utilisateur Page 135