Avaya BCM 4.0 Networking Guide de configuration télécharger pdf (Page 602)

100

101

602 Chapter 65 Configuring DHCP

N0060606N0060606

3 Click the Subnets tab.

4 Click the remote scope you want to modify.

The Scope Specific details panel appears.

5 Click the Address Ranges tab.

The Address Range panel appears.

6 On the Configuration menu, click Add.

The Address Range dialog box appears.

7 Configure the Address Range attributes. Refer to the information in Table 148.

8 Click OK.

To modify a remote scope address range

1 Click Configuration > Data Services > DHCP Server.

2 Select DHCP Server.

3 Click the Subnets tab.

4 Click the remote scope you want to modify.

The Scope Specific Options details panel appears.

5 Click the Address Ranges tab.

The Address Range panel appears.

6 Click an address in the Address Range table.

7 Click Modify.

The Address Range dialog box appears.

8 Modify the Address Range settings.

Table 148 Remote Scope Address Range attributes

Attribute Definition

From IP Address Specify a the first IP address in the Address Range.

To IP Address Specify a the last IP address in the Address Range.

Make sure the start address and end address are in the same subnet.

Note: You cannot add exclude addresses in an address range. Instead, you can

use multiple address ranges:

• Create one address range for the IP addresses below the excluded addresses.

• Create a second address range for the IP addresses above the excluded

addresses.

For example, to create an address range from 10.10.10.10 to 10.10.10.49, but

excluding addresses from 10.10.10.20 to 10.10.10.29, create one address

range from 10.10.10.10 to 10.10.10.19 and one address range from

10.10.10.30 to 10.10.10.49

1 2 ... 597 598 599 600 601 602 603 604 605 606 607 ... 757 758

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 4.0 Networking Guide de configuration Page 602

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya BCM 4.0 Networking