Avaya BCM 4.0 Networking Guide de configuration télécharger pdf (Page 242)

100

101

242 Chapter 22 CLID: Name display

N0060606N0060606

Calling Party Name with status of Private can appear on the Called Party telephone as Private

name. If the incoming Calling Name is defined by the CO as a private name, then Private name

appears on the answering telephone. If the Calling Party Name is unavailable it can appear on the

Called Party telephone as Unknown name.

If the call is answered by a Hunt group, the hunt group name appears instead of the telephone

name in forming the connected name.

The Connected Name is a transient display that appears for approximately three seconds. The

Connected Name is sent only if the OLI is programmed. You can program both a public and

private OLI. The system uses the one appropriate to the type of call.

Network name display interactions

Calling and Connected Name information (if available) passes between trunks with Selective Line

Redirection (SLR). Only Calling Name information passes between trunks in cases where Direct

System Inward Access (DISA) results in tandeming of trunks.

Outgoing name display

You can set up the trunks to disallow name display to be sent out on PRI, BRI, and VoIP trunks.

Use this for trunks where the connecting switch does not support outgoing line display. Default is

enabled.

Business name display

Nortel recommends that you use a blank space for the last character of the Business name to act as

a separator between the Business name and telephone name. A maximum of eight characters is

supported.

Alpha tagging for name display

You can configure your system to display a caller name for incoming calls that provide

number-only CLID, such as if the name service is not subscribed to or available in your area

Note: Lines that provide name and number CLID, such as PRI lines, use

that name for display, rather than the alpha tagging feature.

1 2 ... 237 238 239 240 241 242 243 244 245 246 247 ... 757 758

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 4.0 Networking Guide de configuration Page 242

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya BCM 4.0 Networking