Avaya BCM 4.0 Networking Guide de configuration télécharger pdf (Page 250)

100

101

250 Chapter 23 Configuring CLID on your system

N0060606N0060606

3 In order for the telephone to display the name, it must have Caller ID set for the line assigned

to the telephone. Refer to “Line Access - Line Assignment tab” in the BCM 4.0 Device

Configuration Guide (N0060600).

4 As well, First display must be set to Name. Refer to “Capabilities and Preferences main tab”

in the BCM 4.0 Device Configuration Guide (N0060600).

Programming line name display (incoming)

Answered calls can display the name, incoming number, and line name/number for calls coming in

over lines that allow full CLID.

Lines are named by their number as a default. However, you can provide a more descriptive

identifier. The Name field is located on the main table under Telephony > Lines (“Trunk/Line

Data, main panel” in the BCM 4.0 Device Configuration Guide (N0060600)).

On the Hunt group record (Telephony > Hunt Groups > Hunt Groups table), you can change

the Hunt group Name field from the Hunt group DN to a more logical label for the group. Note

that only eight characters display. Refer to “Hunt Groups system setup” in the BCM 4.0 Device

Configuration Guide (N0060600).

Programming outgoing CLID

Telephones can transmit a business name, telephone name and number (outgoing line identifier)

for outgoing calls over trunks to switches that support outgoing name and number (ONN) display,

or between telephones within the system. This section describes the different areas where these

capabilities are configured.

Programming Business name display (outgoing)

Nortel recommends that you use a blank space for the last character of the Business name to act as

a separator between the Business name and telephone name.

Note that if you leave this field blank, no name appears.

To program the Business Name, select Configuration > Telephony > Global Settings > General

> Global Telephony Settings panel > top panel.

To program the Business Name

1 Click the field beside Business Name.

2 Type a maximum of eight characters for a name.

Leave a blank space for the last character of the Business name to act as a separator between

the Business name and telephone name.

3 Other areas that you must program include:

1 2 ... 245 246 247 248 249 250 251 252 253 254 255 ... 757 758

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 4.0 Networking Guide de configuration Page 250

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya BCM 4.0 Networking