Avaya BCM 4.0 Networking Guide de configuration télécharger pdf (Page 101)

100

101

101

BCM 4.0 Networking Configuration Guide

Chapter 6

Configuring resources — media bay modules

The following describes the Element Manager headings that define and control the settings for the

media bay modules installed on your system.

The following paths indicate where to access the media bay modules in Element Manager and

through Telset Administration:

• Element Manager: Configuration > Resources > Telephony Resources

• Telset interface: **CONFIG > Hardware

Refer to the following topics:

• “Explaining the Media Bay Modules headings” on page 102

• “Defining trunk module types and settings” on page 108

• “Internally-driven channels” on page 117

• “Working with the modules” on page 118

Media bay modules provide the BCM with physical interfaces to trunk (CO) lines and your system

telephones, which are defined by directory number (DN) records. When media bay modules are

first installed in your system, you need to configure them using the procedures described in this

section. Media bay module DIP switch settings and installation procedures are described in the

BCM50 Installation and Maintenance Guide (N027152) and the BCM200/400 4.0 Installation and

Maintenance Guide (N0060612).

Also refer to “Changing the DS30 split” on page 98 for a description of the 2/6 and 3/5 split, which

determines how many channels are available for media bay modules.

Task:

Check settings for the media bay modules installed in the system.

Trunk modules:

• Confirm that the DIP switch setting matches the intended DS30 bus placement.

• Verify that the module type and programmed bus type settings under the intended DS30 bus are correct

for the type of module installed.

• Configure the module parameters of the individual modules installed on each DS30 bus.

Station modules:

• Confirm that the DIP switch setting matches the intended DS30 bus placement.

• Verify that the module type and programmed bus type settings under the intended Bus # are correct for

the type of module installed.

Note: Data and split-telephony/data module configuration are described in “Data modules” on

page 525.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 757 758

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 4.0 Networking Guide de configuration Page 101

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya BCM 4.0 Networking