Avaya BCM 4.0 Networking Guide de configuration télécharger pdf (Page 563)

100

101

Chapter 62 Configuring the Dial-up resources 563

BCM 4.0 Networking Configuration Guide

Figure 179 Deleting a PPPoE Interface

Auto dial-out

Management applications such as SNMP trap dial out, Scheduled Log transfer, Scheduled Backup,

and Scheduled CDR records transfer can use automatic dial-out over an ISDN or Modem

interface. To configure the automatic data transfer, the administrator must configure a static route,

with the auto dial-out field selected, and associate it with the application. When data is sent to the

destination address, the network recognizes the address of the application, and triggers the dial-out

to establish the connection.The packets are then sent over the link to the destination.

Notes:

• The dial-out interface must be enabled to configure static routes.

• The disconnect time for the interface must be greater than 60 seconds. This is configured on

the Link Parameters tab of the selected interface under Configuration > Resources >

Network Interfaces.

• Auto dial-out routes cannot be added if the interface is already manually connected, unless the

interface is already connected with auto dial-out routes configured.

1 2 ... 558 559 560 561 562 563 564 565 566 567 568 ... 757 758

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 4.0 Networking Guide de configuration Page 563

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya BCM 4.0 Networking