Avaya BCM 4.0 Networking Guide de configuration télécharger pdf (Page 197)

100

101

Chapter 14 Configuring lines: T1-Loop start 197

BCM 4.0 Networking Configuration Guide

Configuring digital (T1/E1) loop start lines

The following procedure describes the fields that need to be confirmed or set for these lines. For

detailed field descriptions, refer to “Configuring lines” on page 165.

To configure digital loop start lines

1 Confirm or change the settings on the Trunk/Line Data main panel:

• Line: Read-only list shows available lines for system.

• Trunk Type: Loop.

• Control Set: If you use schedules, enter DN for telephone that controls line schedules.

• Prime Set: If you want the line to be answered at another telephone if the line is not

answered at the target telephone, otherwise, choose None.

• Pub. Received #: Not applicable.

• Priv. Received #: Not applicable.

Under the Parameters tab:

• Name: Default name is line number, shown as part of incoming CLID.

• Line Type: Define as public, if the line is shared or as Private To (DN) if the line is

assigned to a specific telephone, or put it in a line pool (A to O).

• Distinct Ring: If you want this line to have a special ring, indicate a pattern (2, 3, 4, or

None).

Under the Properties tab:

• Trunk mode: Define whether the line will detect the open switch interval (OSI) when a call

is released (supervised). Note: UK profiles use Loop guarded/Loop unguarded.

• Dial mode: The line service will dictate whether this needs to be set to Pulse or Tone

(DTMF) dialing.

2 Configure the trunk/line data (Preferences tab):

• Auto privacy: If you activate this feature, the line is available only to the telephone that

answers the call.

• Full autohold: This allows telephones to put a line on hold if the user picks up another line

or starts to dial out on another line.

• Aux. ringer: If your system is equipped with an external ringer, you can enable this setting

to allow this line to ring at the external ringer.

• Distinct rings in use: Indicates if a special ring has been assigned.

• Answer mode/Answer with DISA: If this line is used for remote call-ins, determine how

you want the line to answer (automatically, or requiring more user input). If the answer

mode is set to Auto, decide whether the caller will be immediately connected to the system

or whether a stuttered dialtone will require the caller to enter a CoS password.

• Voice Message Center: If the system is using a remote voice mail, pick the center

configured with the contact number.

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 757 758

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 4.0 Networking Guide de configuration Page 197

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya BCM 4.0 Networking