Avaya BCM 4.0 Networking Guide de configuration télécharger pdf (Page 249)

100

101

Chapter 23 Configuring CLID on your system 249

BCM 4.0 Networking Configuration Guide

Programming incoming CLID

Telephones can receive Name, Number, and Line display for incoming calls over trunks that

support CLID or between telephones within the system. The following describes the different

areas where these capabilities are configured.

Digital, analog, and VoIP lines support CLID for incoming calls, and there is no special

programming to allow the feature on these lines for BCM digital or IP phones.

Allowing CLID for telephones (incoming)

Target lines and analog CLID trunks connected to a GATM:

1 Under Configuration > Telephony > Sets > Active Sets > Line Access, select the DN record

for a telephone assigned with analog lines that support CLID.

2 On the Line Assignment table, select a line that supports CLID.

3 Select the check box beside the Caller ID set field of the highlighted row.

4 Repeat the procedure for each line assigned to the telephone.

5 Repeat above steps for telephones assigned with these lines.

Using alpha tagging for name display (incoming)

To set up alpha tagging on your system

1 To determine the name to display, you add a system speed dial for the number, entering a

display name. Refer to “Configuring system speed dial numbers” in the BCM 4.0 Device

Configuration Guide (N0060600).

2 To determine how many digits of the dialed number and the system speed dial must match

before a name is displayed, you set the Clid match length setting to the required number

(1 to 8).

Note: If no configuration is done, CLID will show up after answering a

call unless Feature 811 is used. To make CLID appear before answer,

you must set the Caller ID set on the set programming.

Note: Only 30 telephones can be assigned CLID for a line.

Note: You can increase the default number of system speed dials from 70 to 255 if you

want to provide an extensive CLID list.

1 2 ... 244 245 246 247 248 249 250 251 252 253 254 ... 757 758

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 4.0 Networking Guide de configuration Page 249

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya BCM 4.0 Networking