Avaya BCM 4.0 Networking Guide de configuration télécharger pdf (Page 299)

100

101

Chapter 26 Dialing plan: Routing and destination codes 299

BCM 4.0 Networking Configuration Guide

Figure 98 Destination codes table panel

Table 63 describes the fields on the destination codes frame.

Table 63 Destination codes table

Attribute Value Description

Destination Code <max. 12 digits> This number precedes a telephone number to tell the system

where the call needs to be routed. An A in the destination code

represents an any character designation. The A code is a

wildcard.

Normal Route <configured route #> This is the route that the system will use when the destination

code is added to the dial string.

Absorbed Length All, None, 1-X This indicates how much of the destination code gets removed

before the system sends the dial string to the network.

Wild Card 0 - 9 Included, Excluded,

Unavailable

If you enter the wild card character A at the end of a destination

code, then the following applies:

Included: This number can be dialed as part of the destination

code.

Excluded: This number will not be accepted as part of a

destination code string because it is already used in the system.

Unavailable: This number is already defined in another destination

code and cannot be used.

Actions

Add 1. Under the Destination Codes table, click Add.

2. Enter the new destination code.

3. Click OK to save the route settings.

4. On the Destination Codes table, select the fields beside the route you just created, and

modify them, as required.

5. Test the route.

Delete 1. On the Destination Codes table, select the destination code you want to delete.

2. In the Destination Codes pane, click Delete.

3. Click OK.

1 2 ... 294 295 296 297 298 299 300 301 302 303 304 ... 757 758

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 4.0 Networking Guide de configuration Page 299

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya BCM 4.0 Networking