Avaya BCM 4.0 Networking Guide de configuration Page 109

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 758
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 108
Chapter 6 Configuring resources — media bay modules 109
BCM 4.0 Networking Configuration Guide
The fields that appear on the module screen vary depending on the module type you specify. Trunk
lines can also require configuration of settings such as the protocol type/version, frame structure,
clocking, and timers. These parameters depend on how the service provider interface that connects
the module is configured.
Refer to the following topics:
“Configuring the trunk module to line type” on page 109
“Determining clock sources for DTMs or BRIs” on page 110
“T1 interface parameters (region-specific)” on page 111
“E1 parameters (region-specific)” on page 113
“PRI Call-by-Call service selection” on page 114
“Provisioning lines (PRI, T1, DASS2)” on page 116
Configuring the trunk module to line type
Follow these steps to define the modules to the system:
1 Click Configuration > Resources > Telephony Resources.
2 Click the Module you want to program.
The details panel for that bus appears. Figure 25 shows an example of the fields that display
for a PRI module type.
The module installed in the system and Module Type must match the defined type of loop or
trunk and associated services provided by the central office line that you intend to connect to
the module.
Check the settings to ensure they reflect the line requirements. Note that only some of the
fields appear for all module types.
3 If your module is set to T1, PRI, or DASS2, refer to “To configure Call-by-Call services and
the PRI lines” on page 181 to continue with the configuration.
4 After you complete your module configurations, refer to “Configuring lines” on page 165 to
set up the lines the trunk modules will use.
Note: When you configure a media bay module for PRI or BRI, the
system may download new software to the module. This takes a couple
of minutes to complete. Allow the download to finish before continuing
to program the module.
Tip: To refresh the record, you may need to click another navigation tree
heading and then re-enter the module record you were working on.
Vue de la page 108
1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 757 758

Commentaires sur ces manuels

Pas de commentaire