Avaya BCM 4.0 Networking Guide de configuration télécharger pdf (Page 540)

100

101

540 Chapter 62 Configuring the Dial-up resources

N0060606N0060606

IP address pool <IP address> Enter the IP address BCM assigns when a remote site dials

into the BCM system.

The address mask determines the IP address range. These IP

addresses are used for assigning to remote sites as well as to

the BCM local interface.

For example, if the static IP address is 10.11.16.0 and the

address mask is 255.255.255.240, this gives an address range

of 10.11.16.1 to 10.11.16.15. The first IP address is assigned

to the modem interface i.e. 10.11.16.1 and 10.11.1.2, one for

the local modem interface and the other for the remote

assignment. Subsequent IP addresses are assigned to the

ISDN interfaces, one for the local interface and the other for the

remote assignment.

Note: If you have enabled Web Cache, you must update the

Web Cache page when you change the IP address of the

interface. Refer to “Web Cache page update required” on

page 694.

Default: 10.11.16.0

Address mask <IP address> Enter the IP address mask corresponding to the IP address

range. The IP addresses from the static address pool then

reserved for assignment to remote sites.

Default: 255.255.255.0

Actions

Modify <button> Click to modify the dial-in parameter details.

Modem Dial-in Parameters

Number of rings <1-20> The number of rings the BCM will wait before accepting the

call.

Default: 1.

Callback retries <1-10> This parameter is the number of attempts made by the BCM

when trying to connect to the remote-end during callback.

Default: 3.

Callback intervals(s) <0-65536> The interval between successive connection attempts.

Default: 60 seconds.

Authentication PAP

CHAP

PAP & CHAP

Specify PAP or CHAP to force the far end to conform to that

protocol. When you select PAP & CHAP you allow the far end

to negotiate which protocol to use.

Default: PAP & CHAP

MTU <128-16384> Maximum size of the packets that will be sent.

Default: 1500.

ISDN Dial-in Parameters

Callback retries <0–10> This parameter is the number of attempts made by the BCM

when trying to connect to the remote-end during callback.

Default: 3.

Table 20 Dial-in Parameters panel fields (Sheet 2 of 3)

Attribute Value Description

1 2 ... 535 536 537 538 539 540 541 542 543 544 545 ... 757 758

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 4.0 Networking Guide de configuration Page 540

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya BCM 4.0 Networking