Avaya BCM 4.0 Networking Guide de configuration télécharger pdf (Page 126)

100

101

126 Chapter 8 Configuring telephony resources

N0060606N0060606

Disconnect

timer

60, 100, 260, 460, or

600 milliseconds

Loop T1

Specify the duration of an Open Switch Interval (OSI) before a call on a supervised external line is

considered disconnected. This setting must match the setting for the line at the central office (CO).

You must enable disconnect supervision by changing the Line Trunk mode attribute. Under the

Telephony Services sub-heading, choose Lines and Line/trunk Data.

Clock Source Primary External

Secondary External

Internal

T1 PRI *BRI S/

*BRI U2 *BRI U4

DASS2

Designates whether the DTM/BRI acts as a primary or secondary timing component for an external

timing source or as the internal timing source.

Note: A BRI module can be programmed with primary/secondary clock source, however, it is

recommended that a BRI module always be set to Internal if a DTM exists on the system to be the

Primary External clock source.

Warning: Changing the clock source may disconnect calls.

If you change the clock source for your system, you may cause your system DTM interface(s) to reset,

resulting in dropped calls. Choose a suitable time to change the clock source and use the Page

feature to inform users of possible service disruptions.

Send Name

Display

Select or clear

PRI *BRI

QSIG

When you select this check box, the system sends a specified outgoing name display (OLI) from the

calling telephone.

Appears only for Protocols: SL-1, NI, DMS100, DMS250, or PRI QSIG.

Remote

Capability MWI

Select or clear

PRI

This setting allows you to indicate MWI compatibility on the specific loop(s) that you are using to

connect to the central voice mail system on a Meridian 1 which has the MWI package installed, with

the RCAP setting set to MWI.

Appears only for SL-1 protocol.

Overlap

receiving

BRI

Supports target lines in markets which use Overlap receiving signalling on the BRI trunks. Overlap

receiving must be configured for each BRI loop. After every digit is received at the ISDN layer, Target

Lines are checked for matches. If a full match is made, the call is routed immediately to the target line

without waiting for additional digits.

Local Number

Length

BRI

When Overlap receiving is enabled on the trunks, this number determines how many incoming digits

need to match the target line numbers to be considered a call for that target line.

Host node M1, Embark, IDPX,

DSM

DNPSS

DPNSS cards connected to Embark switches have a different way of handling call diversion, therefore,

when you provision a DTM for DPNSS, you must indicate what type of switch the lines are connected

to.

When you select the Embark switch, calls are diverted using the Call Forwarding feature instead of

call diversion.

Table 25 Module parameters values (Sheet 3 of 4)

Attribute Value Module/line type

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 757 758

Commentaires sur ces manuels

Pas de commentaire

Avaya BCM 4.0 Networking Guide de configuration Page 126

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Avaya BCM 4.0 Networking