Avaya Troubleshooting Routers Guide de dépannage télécharger pdf (Page 84)

Troubleshooting Routers

5-6

Troubleshooting an Ethernet Connection

This section assumes that you have isolated a problem to an Ethernet connection.

If not, refer to Chapter 2 to determine whether these instructions apply to your

problem.

Troubleshoot as follows:

1. Filter the log to display only messages from the CSMACD entity running

on the slots experiencing the problem. The Technician Interface

command is

log -fftwid -eCSMACD -s

<slot_no.>

Example

If you are ﬁltering events from Slots 3 and 4, you enter

log -fftwid -eCSMACD -s3 -s4

If only a single port on the slot is reporting errors, try switching out the

transceiver/hub port the router is connected to, or the actual cable that

connects the router to the transceiver cable or twisted-pair connection.

If the problem persists, verify the conﬁguration of the Ethernet port. Then

switch the problem connection to another Ethernet port. If the errors stop

occurring, you may have a bad Ethernet port and should either replace the link

module or call the Bay Networks Technical Response Center.

3. Use the Technician Interface to look at the values of the following

attributes in the wfCSMACDEntry object. Or, use the wfLine➔

wfCSMACDTable Quick Get path to access them.

• wfCSMACDDelete

This shows whether you conﬁgured CSMACD (1), or whether you did not

(2).

• wfCSMACDEnable

This shows whether CSMACD is enabled (1) or disabled (2) on the line.

• wfCSMACDState

This shows whether CSMACD is up (1), down (2), initializing (3), or not

present (4).

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 253 254

Pas de commentaire

Avaya Troubleshooting Routers Guide de dépannage Page 84