Avaya Troubleshooting Routers Guide de dépannage télécharger pdf (Page 42)

Troubleshooting Routers

1-18

You can also insert an asterisk in place of the instance in a get command to

display all of the values of a single attribute. For example, the following command

displays the wfCSMACDState of all of the instances. The speciﬁcation of the

wfCSMACDState attribute in the csmacd.mib ﬁle states “1” means “up” and “2”

means “down.” Note that you can use this method to display all instances without

having to enter the

list instances

command.

get wfCSMACDEntry.3.*

wfCSMACDEntry.wfCSMACDState.1.1 = 1

wfCSMACDEntry.wfCSMACDState.1.2 = 2

wfCSMACDEntry.wfCSMACDState.10.1 = 1

wfCSMACDEntry.wfCSMACDState.10.2 = 1

You can use the complete MIB number in place of the

speciﬁcation. The parameter descriptions in the conﬁguration manuals list the

MIB number for this reason. SNMP commands also use this syntax.

If you enter a

get command and the message “object does not exist” appears, do

the following:

1. Check the spelling and case of the object name.

2. Conﬁgure and enable the object.

Refer to Using Technician Interface Software for more detailed instructions on

how to use the Technician Interface to display and change the values in the MIB.

The advantage of using the Technician Interface scripts, the Statistics Manager, or

the Conﬁguration Manager instead of the Technician Interface commands is that

you don’t have to know an object, attribute, and instance in order to display or

change a setting. The next two sections introduce you to the Technician Interface

scripts and the Statistics Manager. This manual assumes that you already know

how to use the Conﬁguration Manager.

Note: You can use an asterisk in place of the attribute or instance in a get

command, but you cannot use one in place of both.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 253 254

Pas de commentaire

Avaya Troubleshooting Routers Guide de dépannage Page 42