Avaya Troubleshooting Routers Guide de dépannage télécharger pdf (Page 174)

Troubleshooting Routers

A-22

intf gate spawned - line 202102

The router returns to a “wait_state,” a state in which it is waiting for data.

# 81: mm/dd/yy 14:15:57.372 DEBUG SLOT 2 PCAP Code: 65

wait_state - line 202102

# 82: mm/dd/yy 14:15:58.401 DEBUG SLOT 2 SWSERV Code: 46

Connector COM2: FSM State: RDTR_DISCONNECTED(0)

Connector COM2: FSM Event: RDTR_EVENT_CCT_UP(1); isdn flags: 0x0

# 83: mm/dd/yy 14:15:58.401 INFO SLOT 2 MODEMIF Code: 22

Connector COM2: enable requested on cct 65535

Connector COM2: Starting, raise dtr mode, is modem connected and turned

on?

Connector COM2: Circuit has been brought up.

Dial-on-Demand V.25bis

The following log shows a successful dial-on-demand connection between the

COM1 port in Slot 2 and a modem conﬁgured for V.25bis.

These messages appear only when you click on the port conﬁgured for

dial-on-demand, and set the Debug option under the Modem deﬁnition to

Enabled. If you are using the Technician Interface, set attribute #29 (the debug

attribute) of the object wfModemIfEntry to 1 (1 = enabled, 2 = disabled). The

Debug option is available with Software Version 8.01 and later.

The following message indicates that the Sync software module enabled the

COM1 port.

# 9: mm/dd/yy 13:07:24.725 INFO SLOT 2 SYNC Code: 9

Connector COM1 enabled.

The port completes initialization.

# 10: mm/dd/yy 13:07:24.995 DEBUG SLOT 2 SYNC Code: 16

Connector COM1 initialization complete

Environment address - 3051ea30 Line record address - 3052e03c

Hardware map address - 30526e3c Initialization block -

80007c00

Receive descriptor ring - 80006000 Transmit descriptor ring -

80006800

# 11: mm/dd/yy 13:07:24.995 DEBUG SLOT 2 PCAP Code: 67

interface became local - line 202101

intf gate spawned - line 202101

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 253 254

Pas de commentaire

Avaya Troubleshooting Routers Guide de dépannage Page 174