Avaya Troubleshooting Routers Guide de dépannage télécharger pdf (Page 205)

Using the Technician Interface to Configure and Run Packet Capture

B-17

Enter the following command to change the direction of the packets that Packet

Capture saves:

set wfPktCaptureEntry.10.

<line_no.> <value>

;commit

represents the wfPktCaptureDirection attribute.

<line_no.>

is the number displayed after you issued the get command in “Creating

an Instance of Packet Capture.” To list the current line numbers associated with

Packet Capture, enter the

list instances wfPktCaptureEntry command.

<value> is one of the following:

• 1—Packet Capture will copy only incoming packets.

• 2—Packet Capture will copy only outgoing packets.

• 3—Packet Capture will copy both incoming and outgoing packets.

Example

Enter the following command to conﬁgure Packet Capture to copy both incoming

and outgoing packets associated with Line Number 102101:

set wfPktCaptureEntry.10.102101 3;commit

Conﬁguring a Termination Trigger

By default, Packet Capture terminates only when you issue the command to

terminate it. You can change this default so that Packet Capture terminates

• When the Packet Capture ﬁle ﬁlls.

• Or when it matches a portion of an incoming or outgoing packet to a

hexadecimal number or character string that you specify.

You can issue a command to terminate Packet Capture even if you conﬁgure it to

terminate on its own.

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 253 254

Pas de commentaire

Avaya Troubleshooting Routers Guide de dépannage Page 205