Avaya Troubleshooting Routers Guide de dépannage télécharger pdf (Page 219)

Using the Technician Interface to Configure and Run Packet Capture

B-31

2. Issue the following command to establish an FTP connection with the

router.

open

<IP_address>

is the IP address of the router.

Example

connect 1.1.1.1

3. Enter the following command to specify that the ﬁle to be transferred is

binary:

mode binary

4. Enter the following command to retrieve a copy of the ﬁle:

get

<ﬁlename>

<ﬁlename.>

is the name displayed after you issued the get command in

“Getting the Name of the P

acket Capture File.”

Example

get PCAP0400

5. Enter the following command to terminate FTP:

quit

Using TFTP to Transfer the File

When you use TFTP to get a Packet Capture ﬁle, the TFTP software transfers it

from the processor’s memory instead of the media.

The procedure for using TFTP to transfer a copy of a ﬁle to a Sun workstation or

PC depends on the implementation of TFTP on that system. The following

instructions apply to Sun workstations. If you are using a PC and need instructions

for using TFTP, refer to the documentation for the TCP/IP stack installed on

the PC.

Enter the following commands at the command line interface of the Sun

workstation:

1. Issue the following command to start TFTP:

tftp

1 2 ... 214 215 216 217 218 219 220 221 222 223 224 ... 253 254

Pas de commentaire

Avaya Troubleshooting Routers Guide de dépannage Page 219