Avaya Troubleshooting Routers Guide de dépannage télécharger pdf (Page 193)

Using the Technician Interface to Configure and Run Packet Capture

B-5

Assigning the Processors to Run Packet Capture

To assign processors to run Packet Capture, you determine which slots in the

router contain the circuits from which you want to copy packets. Then enter the

following Technician Interface command to assign the processors:

set wfProtocols.26.0

<slot_mask>

;commit

represents the wfPktCaptureLoad attribute (parameter).

<slot_mask>

is a hexadecimal number representing one or more slots containing

circuits or channels from which you want to copy packets.

If you want Packet Capture to copy packets from circuits in a single I/O module,

use the associated slot mask listed in T

able B-1.

Example

To load Packet Capture on Slot 2, enter

set wfProtocols.26.0 0x40000000;commit

Table B-1. Determining the Slot Mask

Slot No. Slot Mask

1 0x80000000

2 0x40000000

3 0x20000000

4 0x10000000

5 0x08000000

6 0x04000000

8 0x01000000

9 0x00800000

10 0x00400000

11 0x00200000

12 0x00100000

13 0x00080000

14 0x00040000

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 253 254

Pas de commentaire

Avaya Troubleshooting Routers Guide de dépannage Page 193