Avaya Business Communications Manager 5.0 - Fault and Performance Management Manuel d'utilisateur télécharger pdf (Page 26)

26 Using the BCM fault management system

Nortel Business Communications Manager 5.0

Fault and Performance Management

NN40170-701 01.01 Standard

August 2009

• whether to display selected alarms in the Alarms table; by default all

Critical, Major, Minor, and Warning alarms are displayed in the Alarms

table

• whether to display selected alarms on the alarm set; by default, only core

telephony Critical and Major alarms are sent to this set

• use email forwarding

Notifying and selecting an alarm profile

Use the Alarm Setting panel to select the Notification Type which describes

where the alarm will be presented and Profile Selection which selects an

alarm profile.

Notify and select an alarm profile

Use the following procedure to select a Notification Type and an Alarm Profile.

Step Action

1 Click on the Administration tab.

2 Open the General folder, and then click the Alarm Settings task.

The Alarm Settings panel opens.

3 Select the Notification Type that you want from the list.

4 Select the Profile Selection that you want from the list.

--End--

Enabling or disabling SNMP traps for alarms

Use the following procedure to enable to disable SNMP traps for alarms.

Procedure steps

Step Action

1 Click the Administration tab.

2 Open the General folder, and then click the Alarm Settings task.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 69 70

Pas de commentaire

Avaya Business Communications Manager 5.0 - Fault and Performance Management Manuel d'utilisateur Page 26