Avaya Business Communications Manager 5.0 - Fault and Performance Management Manuel d'utilisateur télécharger pdf (Page 25)

Using the BCM fault management system 25

Nortel Business Communications Manager 5.0

Fault and Performance Management

NN40170-701 01.01 Standard

August 2009

Clearing an alarm from the alarm set

Use the following step to clear an alarm from the alarm set.

Procedure steps

Step Action

1 On the alarm set, press the Clear soft key. The alarm is cleared from the

alarm set.

--End--

Responding to LED indicators

Use the Business Element Manager to reset the Status LEDs on the front

panel of the BCM to a normal state.

Reset the status LED

Use the following steps to reset the status LED.

Procedure steps

Step Action

1 Click the Administration tab.

2 Open the General folder, and then click the Alarms task.

The Alarms pane opens

3 On the Alarms pane, click the Reset LEDs button.

The Status LED on the front panel of the BCM is reset from red to normal

operation green.

--End--

Configuring alarm behavior

Configure alarm behavior to specify the following settings for alarms:

• the maximum number of alarms to display in the Alarms Panel (from 100

to 1000)

• whether to enable or disable SNMP traps for selected alarms; if you have

specified an SNMP trap destination, by default you will receive all Critical

and Major alarms

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 69 70

Pas de commentaire

Avaya Business Communications Manager 5.0 - Fault and Performance Management Manuel d'utilisateur Page 25