Avaya Business Communications Manager 5.0 - Fault and Performance Management Manuel d'utilisateur télécharger pdf (Page 11)

Nortel Business Communications Manager 5.0

Fault and Performance Management

NN40170-701 01.01 Standard

August 2009

Fault and performance management

fundamentals

The information in this chapter applies to both the BCM50 and the BCM450

platforms running BCM 5.0.

This section provides information about managing alarms generated by the

system and administering alarm settings.

Navigation

• BCM fault management scope (page 11)

• BCM alarms (page 12)

• Alarm administration (page 12)

• Alarm to email forwarding (page 16)

• Alarms and LEDs (page 18)

• SNMP traps manager for remote monitoring (page 18)

• Alarm configuration scope (page 19)

BCM fault management scope

You can view and manage real-time alarms generated by the BCM system.

Alarms arise from components that run on the system; these alarms indicate

faults or informational conditions that may require resolution from the system

administrator. Examples of alarm conditions include:

• a T1 circuit on the system is down

• an administrator stopped a service that runs on the BCM

You can receive alarm information through any of the following means:

• the Alarms Panel in the Business Element Manager

• the Alarm Banner in the Business Element Manager

• Simple Network Management Protocol (SNMP) traps for remote

management of faults

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 69 70

Pas de commentaire

Avaya Business Communications Manager 5.0 - Fault and Performance Management Manuel d'utilisateur Page 11