Avaya Using Technician Interface Software Manuel d'utilisateur Page 341

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 366
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 340
Using Syslog Messaging to Monitor Router
114088 Rev. A C-33
Host Parameters
This section describes parameters you can configure for each host you add to the
Syslog host table (list of remote UNIX hosts).
Parameter: Host Delete
Attribute Name: wfSyslogHostDelete
Attribute Number: 1
Default: 1 (Create)
Options: 1 (Create)
| 2 (Delete)
Function: Adds or deletes a remote host entry in the Syslog host table. Parameters
associated with this entry collectively define a remote host that will
receive Syslog (event) messages from the router.
Instructions: Set to 1 to add a host to the Syslog host table. Set to 2 to delete a host
from the Syslog host table.
Command:
set wfSyslogHostEntry.wfSyslogHostDelete.
<host_IP_address>
<1
|
2>
Parameter: Messaging Enable
Attribute Name: wfSyslogHostDisable
Attribute Number: 2
Default: 1 (Enable)
Options: 1 (Enable)
| 2 (Disable)
Function: Enables or disables message forwarding from Syslog to the remote host
associated with this host entry.
Instructions: Set to 1 to enable message forwarding from Syslog to the remote host
associated with this host entry. Set to 2 to disable message forwarding
from Syslog to the remote host associated with this host entry.
You can also stop forwarding router events to the host by deleting the
host. (Refer to the Host Delete parameter, wfSyslogHostDelete.) If you
delete a remote host and later decide you want to forward router events to
that host, you must add the remote host again to the Syslog host table.
Command:
set wfSyslogHostEntry.wfSyslogHostDisable.
<host_IP_address>
<1
|
2>
MIB Object ID: 1.3.6.1.4.1.18.3.3.2.15.2.1.2
Vue de la page 340
1 2 ... 336 337 338 339 340 341 342 343 344 345 346 ... 365 366

Commentaires sur ces manuels

Pas de commentaire