
Using Technician Interface Software
5-10 114088 Rev. A
The factory-default filenames are as follows:
ace.out The router software image for the FN, LN, CN, and ALN.
You cannot read or change this file. The system automatically
refers to this binary file for booting instructions unless you use
the
boot command to specify a different router software image.
afn.exe
bn.exe
The router software image for the AFN.
The router software image for the BLN, BLN-2, and BCN.
You cannot read or change this file. The system automatically
refers to this binary file for booting instructions unless you use
the
boot command to specify a different router software image.
afnboot.exe A copy of the combined bootstrap PROM and diagnostics PROM
image for an AFN router.
config The default configuration file.
The system refers to this binary file for configuration data when
booting. You can change the configuration by copying an
alternative configuration file to config. You can also use the boot
command to specify a different configuration file.
This file must have the config filename for the system to
configure automatically after booting. We recommend copying
config to a new backup filename before overwriting it.
debug.al An ASCII file containing aliases (commands that abbreviate long
or multiple commands) that you can use to debug common
network problems. (Refer to “Debugging with Predefined
Aliases” in Chapter 9 to use the aliases in this file.)
frediag.exe A copy of the diagnostics image resident on the diagnostics
PROM of a BLN, BLN-2, or BCN router. You cannot read or
change this file.
freboot.exe A copy of the bootstrap image resident on the bootstrap PROM
of a BLN, BLN-2, or BCN router. You cannot read or change this
file.
Commentaires sur ces manuels