Avaya Configuring Traffic Filters and Protocol Prioritization Manuel d'utilisateur Page 77

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 202
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 76
Outbound Traffic Filter Criteria and Actions
308645-15.0 Rev 00
4-11
Prioritizing Actions
You can apply the following actions to outbound traffic filters for WAN protocols:
High
Directs packets that match the filter criteria and ranges to the High queue
Low
Directs packets that match the filter criteria and ranges to the Low queue
Length
Uses the length of packets to determine the priority queue
Outbound traffic filters with a prioritizing action are called priority filters.
See Chapter 2 for detailed information about protocol prioritization.
Dial Service Actions
You can apply the following actions to outbound traffic filters for interfaces
configured as dial-up lines:
No Call
Packets that match the filter criteria and ranges are dropped and do not initiate
a dial connection. (By default, packets transmitted on dial-on-demand lines
always trigger the router to establish a connection.)
No Reset
Packets that match the filter criteria and ranges are processed but do not reset
the inactivity timer.
Note:
You can apply prioritizing actions only to MCE1, MCT1, and
synchronous interfaces. The Configuration Manager does not support priority
filters on the LAN interfaces.
Note:
Although No Call and No Reset are available when creating any
outbound traffic filter, these actions are useful only on dial-up interfaces such
as synchronous modem lines or MCT1 interfaces configured with ISDN PRI.
Vue de la page 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 201 202

Commentaires sur ces manuels

Pas de commentaire