
Configuring Traffic Filters and Protocol Prioritization
9-8
308645-15.0 Rev 00
To configure ATM protocol priority on existing ATM service records:
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
click on the
ATM1
circuit interface
connector.
The Select Connection Type window opens.
2. Click on
ATM.
The Edit ATM Connector window opens.
Note: If you are creating a new ATM
configuration for this router, the Add Circuit
window opens. You must add the ATM
circuit to the router and complete the initial
ATM configuration before continuing with
step 3. See Chapter 2 in
Configuring ATM
Services
for instructions on creating an ATM
circuit.
3. Click on
Service Attributes
. The ATM Service Records List window
opens (Figure 9-3).
4. Click on the service record on which you
want to configure protocol priority.
5. From the top left of the Configuration
Manager window, select Protocols >
Protocol Priority > Service Level.
The Edit Protocol Priority Interface window
opens (Figure 9-4).
6. Select the parameter you want to
change. To see additional parameters,
use the scroll bar on the right side of the
window.
For a description of the parameter, click
on
Help
, or see the parameter
descriptions beginning on page A-2 in
Appendix A:
• Enable
• High Queue Size
• Normal Queue Size
• Low Queue Size
• Max High Queue Latency
• High Water Packets Clear
• Prioritization Algorithm Type
• High Queue Percent Bandwidth
• Normal Queue Percent Bandwidth
• Low Queue Percent Bandwidth
• Dequeue At Line Rate
Commentaires sur ces manuels