Avaya Configuring Traffic Filters and Protocol Prioritization Manuel d'utilisateur Page 22

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 202
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 21
Configuring Traffic Filters and Protocol Prioritization
1-2
308645-15.0 Rev 00
Nortel Networks routers support two types of traffic filters:
Inbound traffic filters act on packets that the router is receiving.
Outbound traffic filters act on packets that the router is forwarding.
You can create traffic filters on the following router interfaces:
Ethernet (10BASE-T and 100BASE-T)
FDDI
HSSI
MCE1
MCT1
Synchronous
Token ring
You can apply multiple traffic filters to a single interface. When more than one
filter applies to a packet, the order of filters determines the filtering result.
Inbound Traffic Filters
Inbound traffic filters act on packets arriving at a particular router interface. Most
sites use inbound traffic filters primarily for security, to restrict access to nodes in
a network.
When you configure inbound traffic filters, you specify a set of conditions that
apply to the traffic of a particular bridging or routing protocol. The Configuration
Manager supports inbound traffic filters for the following protocols:
Transparent bridge (four encapsulation methods: Ethernet, 802.2 LLC, 802.2
LLC with SNAP, and Novell Proprietary)
Native source route bridging (SRB)
IP
IPX
XNS
OSI
DECnet Phase IV
VINES
DLSw
LLC2 (APPN and LNM)
Vue de la page 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 201 202

Commentaires sur ces manuels

Pas de commentaire