Avaya Configuring Traffic Filters and Protocol Prioritization Manuel d'utilisateur télécharger pdf (Page 157)

ATM Protocol Prioritization and Priority Queuing

308645-15.0 Rev 00

9-3

Displaying the Priority/Outbound Filters Window for ATM

Before you configure ATM protocol priority at either the interface or service

record level, you create and apply outbound traffic filters to one or more virtual

circuits (VCs). You do this from the Priority/Outbound Filters window. There are

two ways to display the Priority/Outbound Filters window for ATM. Once you

access this window, follow the instructions in Chapter 7 to create and apply

outbound traffic filters before beginning the procedures in this chapter.

To display the Priority/Outbound Filters window using the PVC Protocol Priority

option:

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

click on the

ATM1

circuit interface

connector.

The Select Connection Type window

opens.

2. Click on

ATM.

The Edit ATM Connector window opens.

3. Click on

PVC Protocol Priority

. The ATM PVC Protocol Priority window

opens.

4. Click on

Priority/Outbound Filters

. The Priority/Outbound Filters window

opens (Figure 9-1). For information on

creating outbound traffic filter templates

and outbound traffic filters, see

Chapter 7.

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 201 202

Pas de commentaire

Avaya Configuring Traffic Filters and Protocol Prioritization Manuel d'utilisateur Page 157