Avaya Connecting BayStack AN and ANH Platforms to a Network Manuel d'utilisateur télécharger pdf (Page 75)

Configuring Network Booting

4-15

Enable BOOTP relay on an interface as follows:

1. Click on the connector in the Conﬁguration Manager window.

2. Select Edit Circuit in the Edit Connector window.

3. Select Protocols➔Add in the Circuit Deﬁnition window.

4. Select BOOTP in the Select Protocols window and click on OK.

5. Select File➔Exit to exit the Circuit Deﬁnition window.

Creating BOOTP Relay Agent Forwarding Tables

You must create a BOOTP relay agent forwarding table for every router passing

BOOTP trafﬁc between the router and the Site Manager workstation.

The BOOTP relay agent forwarding table allows you to specify the IP interface

that receives the incoming BOOTP request packets, and the associated IP interface

that forwards them. You can add multiple pairs of incoming and outgoing

interfaces to support connections to multiple routers in your network.

To create the BOOTP relay agent forwarding table, begin at the Conﬁguration

Manager window and complete the following steps.

1. Select Protocols➔IP➔BOOTP➔Relay Agent Interface Table in the

Conﬁguration Manager window.

The BOOTP Relay Agent Interface Table window appears (F

igure 4-6). This

window lists all IP interfaces on the router.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 167 168

Pas de commentaire

Avaya Connecting BayStack AN and ANH Platforms to a Network Manuel d'utilisateur Page 75