Avaya Connecting BayStack AN and ANH Platforms to a Network Manuel d'utilisateur Page 150

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 168
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 149
Connecting BayStack AN and ANH Systems to a Network
B-14
Figure B-1. Starting the IP Interface Test
8. To continue the IP configuration test, enter the IP address for the Site
Manager workstation.
To cancel the test, enter
q.
9. When the ANH Technician Interface prompt reappears, type logout and
press the Return key to exit the Technician Interface.
Once the AN/ANH creates and tests the configuration, it starts using the
configuration information you entered. Refer to Configuring Routers to configure
the router using Site Manager.
Testing local IP interface
ping -IP 192.32.00.000 -r5
IP ping: 192.32.00.000 is alive (size - 16 bytes)
IP ping: 192.32.00.000 is alive (size - 16 bytes)
IP ping: 192.32.00.000 is alive (size - 16 bytes)
IP ping: 192.32.00.000 is alive (size - 16 bytes)
IP ping: 192.32.00.000 is alive (size - 16 bytes)
This test attempts to ping the Site Manager workstation.
NOTE: If routing has not yet converged, an attempt
to ping the Site Manager workstation may fail. If
this happens, you may either enter a new IP address or
quit and wait a short period of time and try again from
the TI command line.
Type q<return> to cancel this test.
Enter IP address of Site Manager workstation:
Vue de la page 149
1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 167 168

Commentaires sur ces manuels

Pas de commentaire