Avaya Connecting BayStack AN and ANH Platforms to a Network Manuel d'utilisateur Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 168
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
Hardware and Software Overview
1-7
To initially start up the AN or ANH, you use one of these boot configuration
options:
EZ-Install (the default)
Netboot
Local Boot
To start up the AN/ANH after the initial configuration, you use one of these
options:
Netboot
Directed Netboot
Local Boot
T
able 1-3 summarizes the four startup options. The next section, “The Boot
Process,” describes how each option works.
Table 1-3. Summary of Boot Options
Boot
Option
Source for
Software
Image
Source for
Config File Description and Requirements
EZ-Install
Local
(Flash
memory)
Network
(Synchronous
connection)
The default option. The AN/ANH boots from a software
image in local memory, then transmits a request for its IP
address and configuration file through an attached
synchronous interface.
Next, a remote UNIX- or DOS-based workstation that is
configured as a Boot Protocol (BOOTP) server downloads a
customized configuration file; you save that configuration to
Flash memory.
Requires a communications link over an HDLC or Frame
Relay interface.
If EZ-Install fails, the router tries the Local Boot procedure.
(continued)
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 167 168

Commentaires sur ces manuels

Pas de commentaire