Avaya Connecting BayStack AN and ANH Platforms to a Network Manuel d'utilisateur télécharger pdf (Page 74)

Connecting BayStack AN and ANH Systems to a Network

4-14

Setting Up Routing Paths for Netboot

You set up the routing paths between the BOOTP server and the routers by

• Enabling each router interface in the paths to the routers

• Creating a BOOTP relay agent forwarding table for each router in the path

• Creating a BOOTP client interface table for the upstream router when the

AN/ANH is on a Frame Relay PVC in group access mode

Enabling Router Interfaces

You must enable BOOTP relay (also called BOOTP pass-through or gateway) on

all interfaces in the paths between the AN/ANH routers and the BOOTP server.

For example, you would enable BOOTP relay on the interfaces indicated in

igure 4-5.

Figure 4-5. Enabling BOOTP in a Sample Network

Enable BOOTP on

these interfaces

Corporate backbone

BOOTP server

Booting routers

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 167 168

Pas de commentaire

Avaya Connecting BayStack AN and ANH Platforms to a Network Manuel d'utilisateur Page 74