Avaya Connecting BayStack AN and ANH Platforms to a Network Manuel d'utilisateur télécharger pdf (Page 151)

C-1

Appendix C

Implementation Notes

This appendix contains implementation hints, a few important notes you could

have missed earlier in this guide, and guidelines for planning ANH network

conﬁgurations.

Hints

This section contains a few hints for setting up an AN or ANH.

• We recommend that you ﬁrst install an AN/ANH in the same site as your

BOOTP server, Site Manager workstation, and intermediate Bay Networks

routers to test the software image, conﬁguration ﬁle, and routing path. This

test provides you with the startup and troubleshooting experience you need to

perform these tasks on routers at remote sites. After you perform the test,

move the test router to the remote location you want, modify the conﬁguration

ﬁle for that router, and set up the new paths.

• After you build and test the remote router conﬁguration ﬁle, make copies of it

on the Site Manager workstation. Then modify the copies for each AN/ANH

in your network, rather than starting over. To avoid mix-ups, make sure the

ﬁlename you assign to each conﬁguration ﬁle is unique and meaningful for

each router.

• It may be easier to isolate BOOTP and TFTP conﬁguration errors on the

network if you upgrade all Bay Networks routers in the paths between the

routers and the BOOTP server to Version 7.80 or higher before you set up the

paths.

1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 167 168

Pas de commentaire

Avaya Connecting BayStack AN and ANH Platforms to a Network Manuel d'utilisateur Page 151