Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur télécharger pdf (Page 94)

94 Chapter 2 General CLI commands

212160-A

flowcontrol command

The flowcontrol command is used only on Gigabit Ethernet ports and controls

the traffic rates during congestion. The syntax for the

flowcontrol command is:

flowcontrol [port <portnum>]

{asymmetric|symmetric|auto|disable}

The flowcontrol command is in the config-if mode.

Table 42 describes the parameters and variables for the

flowcontrol command.

no flowcontrol command

The no flowcontrol command is used only on Gigabit Ethernet ports and

disables flow control. The syntax for the

no flowcontrol command is:

no flowcontrol [port <portnum>]

The no flowcontrol command is in the config-if mode.

Table 42 flowcontrol command parameters and variables

Parameters and

variables

Description

port <portnum> Specifies the port number to configure for flow control.

Note: If you omit this parameter, the system uses the port

number you specified in the

interface command.

asymmetric|symmetric|

auto|disable

Sets the mode for flow control:

• asymmetric—enables the local port to perform flow control

on the remote port

• symmetric—enables the local port to perform flow control

• auto—sets the port to automatically determine the flow

control mode (default)

• disable—disables flow control on the port

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 199 200

Pas de commentaire

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur Page 94