Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur télécharger pdf (Page 64)

64 Chapter 2 General CLI commands

212160-A

Figure 12 show ip command output

Setting Telnet access

You can also access the CLI through a Telnet session. To access the CLI remotely,

the management port must have an assigned IP address and remote access must be

enabled. You can log on to the switch using Telnet from a terminal that has access

to the BPS 2000.

To open a Telnet session from Device Manager, click on the Telnet icon on the

toolbar (Figure 13) or click Action > Telnet on the Device Manager toolbar.

Figure 13 Telnet icon on Device Manager toolbar

You can view the Telnet allowed IP addresses and settings, change the settings, or

disable the Telnet connection. This section covers the following topics:

Note: Multiple users can access the CLI system simultaneously, through

the serial port, Telnet, and modems. The maximum number of

simultaneous users is four plus one each at the serial port for a total of 12

users on the stack. All users can configure simultaneously.

BPS2000>show ip

BootP Mode: BootP Disabled

Configured In Use Last BootP

--------------- --------------- ---------------

Stack IP Address: 10.10.40.29 10.10.40.29 0.0.0.0

Switch IP Address: 0.0.0.0 0.0.0.0

Subnet Mask: 255.255.255.0 255.255.255.0 0.0.0.0

Default Gateway: 10.10.40.1 10.10.40.1 0.0.0.0

BPS2000>

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 199 200

Pas de commentaire

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur Page 64