
Chapter 2 General CLI commands 93
Reference for the Business Policy Switch 2000 Command Line Interface
no autotopology command
The no autotopology command disables the Autotopology protocol. The
syntax for the
no autotopology command is:
no autotopology
The no autotopology command is in the config command mode.
The
no autotopology command has no parameters or values.
default autotopology command
The default autotopology command enables the Autotopology protocol. The
syntax for the
default autotopology command is:
default autotopology
The default autotopology command is in the config command mode.
The
default autotopology command has no parameters or values.
Enabling flow control
If you use a Gigabit Ethernet MDA with the BPS 2000, you control traffic on this
port using the
flowcontrol command. This section covers the following
commands:
• “flowcontrol command,” next
• “no flowcontrol command” on page 94
• “default flowcontrol command” on page 95
Commentaires sur ces manuels