Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur télécharger pdf (Page 83)

Chapter 2 General CLI commands 83

Reference for the Business Policy Switch 2000 Command Line Interface

Figure 18 show logging command output

set logging

The set logging command configures the system settings for the system event

log. The syntax for the

set logging command is:

set logging [enable|disable] [level

critical|serious|informational] [nv-level

critical|serious|informational|none]

The set logging command is in the config command mode.

Table 32 describes the parameters and variables for the

set logging command.

Table 32 set logging command parameters and values

Parameters and variables Description

enable|disable Enables or disables the event log (default is enabled).

level critical|serious|informational Specifies the level of logging stored in DRAM.

nv-level critical|serious|informational|none Specifies the level of logging stored in NVRAM.

BPS2000#show logging informational

Type Unit Time Index Src Message

---- ---- ----------- --------- --- -------

I 1 00:00:01:52 1 Warm Start Trap

I 1 00:00:01:52 2 Enterprise Specific Trap

I 1 00:00:01:57 3 Link Up Trap

I 1 00:00:01:57 4 Link Up Trap

I 1 00:00:01:57 5 Link Up Trap

I 1 00:00:01:57 6 Link Up Trap

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 199 200

Pas de commentaire

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur Page 83