Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur télécharger pdf (Page 174)

174 Chapter 6 Policy-enabled networks and QoS

212160-A

qos queue-set-assignment command

The qos queue-set-assignment command associates the 802.1p priority

values with a specific queue within a specific queue set. This association

determines the egress scheduling treatment that traffic with a specific 802.1p

priority value receives. The syntax for the

qos queue-set-assignment

command is:

qos queue-set-assignment queue-set <setid> 1p <ieee1p>

queue <qid>

The qos queue-set-assignment command is in the config command mode.

Table 100 describes the parameters and variables for the

qos

queue-set-assignment

command.

Configuring QoS filters and filter groups

You can configure filters and filter sets using the CLI. This section covers:

• “qos ip-filter command,” next

• “qos ip-filter-set command” on page 176

• “qos l2-filter command” on page 177

• “qos l2-filter-set command” on page 179

Table 100 qos queue-set-assignment command parameters and variables

Parameters

and variables

Description

queue-set

<setid>

Enter the queue set ID.

1p <ieee1p> Enter the 802.1p priority value for which the queue association is

being modified; range is between 0 and 7.

queue <qid> Enter the queue within the identified queue set to assign the 802.1p

priority traffic at egress.

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 199 200

Pas de commentaire

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur Page 174