Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur télécharger pdf (Page 132)

132 Chapter 4 Spanning Tree, MLT, and Port-Mirroring

212160-A

Using MLT

You configure Multi-Link Trunking (MLT) using the following commands:

• “show mlt command,” next

• “mlt command” on page 133

• “no mlt command” on page 134

show mlt command

The show mlt command displays the Multi-Link Trunking (MLT) configuration

and utilization. The syntax for the

show mlt command is:

show mlt [utilization <1-6>]

The show mlt command is in the privExec command mode.

Table 73 no spanning-tree command by port parameters and variables

Parameters and

variables

Description

port <portnum> Disables spanning tree for the specified port or ports; enter port

or ports you want enabled for STP.

Note: If you omit this parameter, the system uses the port

number you specified when you issued the interface

command.

stp <1-8> Disables the port in the specified spanning tree group; enter the

STG ID.

Note: For guidelines for configuring STGs, VLANs, and MLTs, refer to

Chapter 1 of the Using the Business Policy Switch 2000 Software Version

1.2.

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 199 200

Pas de commentaire

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur Page 132