Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur télécharger pdf (Page 29)

Chapter 1 CLI Basics 29

Reference for the Business Policy Switch 2000 Command Line Interface

Commands in the Privileged EXEC mode are available to all other modes but the

User EXEC mode. The commands in this mode allow you to perform basic

switch-level management tasks, such as downloading the software image, setting

passwords, and booting the BPS 2000. The Privileged EXEC mode is also

referred to as privExec mode.

The last two command modes allow you to change the configuration of the BPS

2000. Changes made in these command modes are immediately applied to the

switch configuration and saved to NVRAM.

The Global Configuration commands allow you to set and display general

configurations for the switch, such as the IP address, SNMP parameters, the

Telnet access, and VLANs. The Global Configuration mode is also referred to as

config mode.

The Interface Configuration commands allow you to configure parameters for

each port, such as speed, duplex mode, and rate-limiting. The Interface

Configuration mode is also referred to as config-if mode.

Figure 1 provides an illustration of the hierarchy of BPS 2000 CLI command

modes.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 199 200

Pas de commentaire

Avaya Reference for the Business Policy Switch 2000 Command Line Interface Release 1.2 Manuel d'utilisateur Page 29