Avaya Configuring Interface and Router Redundancy Manuel d'utilisateur télécharger pdf (Page 43)

308626-14.00 Rev 00

5-1

Chapter 5

Configuring Router Redundancy

This chapter describes how to configure router redundancy. It assumes you have

read Configuring and Managing Routers with Site Manager and Chapters 2 and 3

of this guide, and that you have already created a local configuration file for a

router without router redundancy.

To enable router redundancy, you must choose at least two routers as members of

a router redundancy group. One of the routers will be the primary router; it will

provide normal routing/bridging services. The other router will be the secondary,

backup router; it will take over if the primary router fails.

When you enable router redundancy, you must configure some group and member

parameters. The Configuration Manager supplies default values for the remaining

parameters. Use the directions that follow to enable router redundancy and edit

router redundancy parameters.

For each parameter, this chapter describes default settings, valid parameter

options, the parameter function, instructions for setting the parameter, and the

MIB object ID.

Note:

You cannot configure router redundancy in dynamic or remote mode.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 89 90

Pas de commentaire

Avaya Configuring Interface and Router Redundancy Manuel d'utilisateur Page 43