Avaya BCM First Time Guide d'installation télécharger pdf (Page 9)

Installation overview / 9

P1012750 Issue 01

Programming the Business Communications Manager system

After you have set the initial configuration parameters, you can connect the Business Communications

Manager system to the network and program the telephony and data networking features. For

information about configuring the telephony and data networking parameters, refer to the Business

Communications Manager Programming Operations Guide.

Additional information

For more information about installing the BCM200 or BCM400 (such as wiring charts and cable

diagrams), refer to the Business Communications Manager BCM200/400 Installation and

Maintenance Guide.

Installing a WAN card

1. Attach one end of the grounding strap to your wrist and the other end to a grounded metal surface.

2. Remove the Base Function Tray latch screws and place them in a safe location.

3. Move the Base Function Tray latches to the unlock position.

4. Grasp the Base Function Tray latches and partially remove the Base Function Tray from the

BCM200 or BCM400. Do not exert force on the DS30 cables or connectors.

5. Disconnect the DS30 cable connectors from the MSC card.

6. Remove the Base Function Tray completely from the BCM200 or BCM400.

7. Place the Base Function Tray on a flat, clean and static-free surface.

8. Remove the bezel screws from the Base Function Tray face and place them in a safe location.

9. Pull the bezel forward until the bezel clips are clear of the Base Function Tray chassis. Move the

bezel in a downward direction between the Base Function Tray latches. Place the bezel in a safe

location.

10. At the front of the Base Function Tray, loosen and remove the PCI plate cover screw (use a #2

Phillips screwdriver). Place the screw in a safe location.

11. Remove the PCI plate cover from the Base Function Tray chassis.

12. Insert the WAN card in the upper PCI slot.

13. Push the card to the left until it sits firmly in the correct PCI Riser card connector.

14. Position the PCI plate cover such that the locking screw holes align.

15. Position the PCI plate cover locking screw in the PCI plate cover and tighten the screw until the

clamp is firmly set in place.

Tip

In certain situations, you may not be able to connect the Business Communications Manager system to the

network and use Unified Manager. (For example, the network is not installed or the network has restricted

access.) In these situations, you can connect to the Business Communications Manager system using an

Ethernet crossover cable and use Unified Manager. With this connection, you can program all of

parameters on the Business Communications Manager system.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Avaya BCM First Time Guide d'installation Page 9