Avaya BCM First Time Guide d'installation télécharger pdf (Page 6)

6 / Installation overview

P1012750 Issue 01

Initializing the Business Communications Manager software

After you connect power to the Business Communications Manager system, you need to set the initial

configuration parameters. One of these initial parameters is the IP address. This IP address is required

to connect to the Business Communications Manager system using Unified Manager. Unified Manager

is the application you use to program the Business Communications Manager system.

The default IP address of the Business Communications Manager system is:

• IP: 10.10.10.1

• Subnet: 255.255.255.0

Ask the network administrator before you connect the Business Communications Manager system to

the network to make sure there are no conflicts.

If you can use the default IP address, refer to Connecting

the network cables on page 6.

If you cannot use the default IP address, refer to Changing the default IP address

on page 11.

Connecting the network cables

1. Connect the data network wiring to the LAN and WAN cards in the BCM.

2. Use the Quick Install wizard to set the initial configuration parameters. For information about the

Quick Install wizard, refer to Using the Quick Start wizard

on page 7.

Note: If you are installing the BCM as a Survivable Remote Gateway (SRG) for Succession

Branch Office, you must enter the SRG keycode before running the Quick Start Wizard.

For information about how to enter the SRG keycode and run the Quick Start Wizard on

a SRG, refer to the BCM200/400 SRG Configuration Guide.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Avaya BCM First Time Guide d'installation Page 6