Avaya BCM First Time Guide d'installation télécharger pdf (Page 5)

Installation overview / 5

P1012750 Issue 01

Installation overview

There are two main steps required to install the Business Communications Manager:

1. Install the Business Communications Manager hardware.

For more information refer to Installing the Business Communications Manager hardware

page 5.

2. Initialize the Business Communications Manager software.

For more information refer to Initializing the Business Communications Manager software

page 6.

Installing the Business Communications Manager hardware

1. Choose a location for the BCM. Make sure this location meets the requirements listed in the

Installation Preparation Checklist section of the Business Communications Manager BCM200/

400 Installation and Maintenance Guide.

Note: If your system includes an Expansion Unit, you should install the Expansion Unit before

you connect the power, telephony or data network wiring. For more information about

installing the Expansion Unit, refer to the Business Communications Manager BCM200/

400 Installation and Maintenance Guide.

2. If you are mounting the BCM in a rack, attach the rack mount brackets to the BCM.

If you are mounting the BCM on a wall, attach the wall mount brackets to the BCM.

If you are mounting the BCM on a table, or other flat, stable surface, attach the four rubber feet to

the BCM.

3. Mount the BCM in the rack, on the wall or on the table.

4. Set the DIP switches on all of the media bay modules you are going to install in the BCM.

5. Remove the cover plates from the media bays you are going to use.

6. Insert the media bay modules into the BCM.

Note: The DTM and DDI MUX media bay modules must be installed in the BCM200 or

BCM400 main chassis, not the Expansion Unit. Problems can occur if these type of

media bay modules are installed in the Expansion Unit.

7. If this Business Communications Manager system includes an optional WAN card, install the

WAN card in the BCM. For instructions on how to install the WAN card, refer to Installing a

WAN card on page 9.

8. Plug the AC power cord into the BCM and the AC power outlet.

9. Connect the telephony wiring of the telephones and peripherals to the BCM.

Note: Do not connect the Public Switched Telephone Network (PSTN) lines to the Business

Communications Manager system until after you connect the AC power cord. Do not

connect the data network wiring until you enter the correct IP address for the Business

Communications Manager system.

For more information about how to install Business Communications Manager equipment, refer to the

Business Communications Manager BCM200/400 Installation and Maintenance Guide.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Pas de commentaire

Avaya BCM First Time Guide d'installation Page 5